VALLEY COMFORT SYSTEMS INC.
1290 COMMERCIAL WAY, PENTICTON, B.C. V2A 3H5 -- PHONE: (250) 493-7444
PAGE
7
ASSEMBLY OF DOOR HANDLE
The door handle should be assembled as shown in the diagram below.
OPERATING YOUR HEATER
Before firing your new Valley Comfort heater - spread an inch of sand or ashes over the floor of the combustion chamber.
This will reduce any danger of warpage due to overheating.
Next. Turn the control knob of the regulator or thermostat to a medium position. This opens the draft damper at the
base of the heater.
Place crumpled newspapers in the heater and cover them with kindling and small pieces of wood. Ignite this and as the
fire grows, add larger pieces of wood.
Do not be alarmed by fuming or smoke the first time you use your heater. This is caused by the high temperature paint
which is simply curing. You may wish to open a few windows to clear the air.
MAKING ADJUSTMENTS
When your home reaches the desired temperature, turn down the knob on the regulator until the large draft damper
closes. The small pilot damper will stay open and the temperature should remain the same without anymore
adjustments, until the fuel level becomes low. With the heater at room temperature and the control knob at the 2.5
setting, adjust the damper chain (if necessary) so that the damper just closes.
