- 16 -
and surface.
Check that the indicator is on zero and, if ne-
cessary, use a screwdriver (not supplied) to
reposition it.
WORK SURFACE TILT ADJUSTMENT
To adjust work surface tilt (pos. 3) to the blade
(pos. 5) use the hand wheel (pos. 4) in order to
tilt the surface to the required angle.
PIECE LOCK AND GUARD HEIGHT ADJUSTMENT
To adjust piece lock and guard height (pos. 14
– 17) to the surface (pos. 3) and work piece
use the hand wheel (pos. 21), adjust and firmly
tighten.
The piece lock should be just over the piece
so as to allow the piece to slide under it while
preventing it from lifting off the surface.
STARTING AND STOPPING
!
!
WARNING! Before starting the machine
it is compulsory to put on goggles, gloves,
headphones and dust mask (not provided with
the machine).
!
!
WARNING! Whilst starting and stopping,
make sure that nobody approaches the machi-
ne. Keep a safe distance to the side and not
facing the machine. Keep safety distance from
all parts in motion and from the cutting area.
!
!
WARNING! The engine, the moving parts
and the blade continue to run for a short while
after the machine is switched off. During this
time, these parts must not be touched. Serious
injury hazard!
Before starting the machine check the integrity
of all the components and that all the bolts and
couplings are tight.
STARTING UP
1) Make sure service keys are inserted.
2) Make sure the guard is correctly positioned
on the cutting area.
3) Insert the power cord plug into the socket.
4) Stand in front of the machine and make sure
people and animals are kept away.
5) To start press the ON ‘I’ switch (switched
on) (pos. 12).
If you notice any working defects, switch off
the machine and consult the chapter “Trou-
bleshooting”.
STOPPING
To stop the machine press the OFF “O” switch
(switched off) (pos. 12).
SPEED ADJUSTMENT (if applicable)
Use the knob (pos. 19) to adjust blade oscillation
speed.
When not using the machine, turn it off and
disconnect the plug from the socket.
OPERATING WARNINGS AND TIPS
!
!
WARNING! Before conducting checks
and adjustments, turn the switch to OFF“O”
(switched off) and unplug the machine from
the electric power supply.
After having read the previous chapters carefully,
apply these tips scrupulously to obtain maximum
performance from your machine. Proceed with
caution. You will only be able to make full use of
the machine’s potential after gaining sufficient
experience. Acquaint yourself with all controls.
Run trials without work pieces.
OPERATOR
The normal operator position is in front of the
machine (switch side), with both hands guiding
and holding the piece; cutting is only possible
from this position.
Warning! Keep your hands and face far from
the blade and cutting area. Serious injury
hazard!
WORK PIECE
The shape, size and weight of the piece to be
cut must be compatible with the machine. Hard
wood is not suited for this machine.
Trace the cutting line on the piece with a pencil;
start the machine and place the piece on the
work surface being careful not to touch the
blade. The wider side of the piece must rest on
the base; do not cut pieces with the wider side
upright (on a slant).
Align the previously traced line with the blade
edge and move it towards the blade; turn the
machine off after cutting.
Specifically sized pieces can be used on this ma-
chine (thickness H and depth P, see Technical Data).
Warning! For your safety, it is important that
the machine is secured to the bench or stand.
