- 14 -
Put all the dismounted pieces in a receptacle
and proceed to clean them using clean diluents
(perhaps recommended by the paint manufac-
turer), and use a paintbrush.
Also clean the inside parts of the gun and the
suction tube (19 Fig.A).
Before fitting these components again make sure
they are properly dry.
Warning!
Replace the components listed fol-
lowing the removal sequence in reverse order.
Warning!
For safety reasons and for the machi-
ne to work properly, the seal on the tank is not
entirely airtight. Even when it has been closed
properly you may detect a small amount of air
escaping.
Cleaning the machine casing
Switch the machine off and disconnect it from
the power supply.
Clean the machine casing and the air hose with
a soft brush or clean damp cloth. Do not use
any detergents or solvents as these may damage
the machine beyond repair. The plastic parts are
prone to damage by chemical agents.
!
!
Always keep the ventilation holes (22
Fig.A) clean and free.
Warning!
Do not spray or soak the machine
with water.
For maintenance not explained in these instruc-
tions, contact an authorised assistance centre.
STORING
- After each use clean the entire machine and all
its accessories properly (see the Maintenance
paragraph). This will prevent mildew from
forming, which will ensure better performance
and a longer working life.
- Keep the machine out of reach of children, in a
stable safe position, in a dry place not subject
to extreme temperatures and free of dust.
- Protect the machine from direct sunlight,
keeping it in the dark where possible, or in the
shade.
- Do not wrap the machine in plastic bags as
dampness could form.
WARRANTY
The product is protected by law against non-
compliance with the declared characteristics
provided it is used only in the manner described
in the instructions, it has not been tampered with
in any way, it has been stored properly, has been
repaired by authorized and, where applicable,
have been used only original spare parts.
In the case of industrial or professional use or
when using such a guarantee is valid for 12
months.
To issue a claim under warranty you must
present proof of purchase to your dealer or
authorized service center.
TROUBLESHOOTING
!
!
WARNING! If the machine vibrates have it
checked by an authorised assistance centre.
!
!
WARNING! If after carrying out the tasks
described in table ‘Problem-Cause-Solution’
the machine still fails to work properly, or
should difficulties arise other than those
indicated, take it to an authorised assistance
centre. Always provide the machine model
and serial number shown on the technical data
label and the enclosed sheet.