- 11 -
g
This painting machine uses an ‘HVLP’ system
that uses high volumes of air at low pressure.
!
!
WARNING! Before using this machine,
in order to ensure that handling, servicing,
starting, use, stopping, and maintenance are
carried out properly, read the instructions be-
low and apply them carefully. Before starting
work you should be familiar with the controls
and the correct use of this machine. Make sure
you know how to stop it in case of emergency.
Incorrect use of this machine may result
in serious injury. This machine may not be
used in places covered by the anti-explosion
standards.
Keep these instructions and the safety in-
structions carefully and close to hand for
consultation in case of need.
Always bear your own safety and that of others
in mind, and act accordingly.
!
!
WARNING! This painting machine is only to
be used for spraying non-inflammable coating
materials such as paints, transparent ena-
mels, etc. that have a flash point higher than
21°C. Do not use with any other type of paint.
!
!
WARNING! Any use other than that indica-
ted in these instructions may damage the ma-
chine and constitute a serious risk to the user.
DESCRIPTION OF THE MACHINE (FIG. A)
1 Power supply plug
2 Hand grip
3 ON/OFF Switch
4 Transport belt
5 Air hose
6 Spray gun
7 Gun holder
8 Casing
9 Flow meter
10 Gun handle
11 Trigger
12 Tank
13 Cover
14 Air suction gun connection
15 Air suction casing connection
16 Paint nozzle
17 Air nozzle
18 Paint flow adjustment screw
19 Paint suction tube
20 Ring
21 Butterfly nozzle
22 Ventilation holes
DESCRIPTION OF MARKS AND SYMBOLS
(FIG. B)
1 Machine model
2 Technical data
3 Double electric insulation
4 CE conformity mark
5 Manufacturing serial number
SETTING UP (FIG. C)
This machine may be supplied with some com-
ponents not fitted. Remove the machine and the
components supplied from the packaging and
proceed to assemble them as illustrated.
While assembling the components the power
supply plug must be disconnected from the po-
wer socket. Before starting the machine, check
that all assembled parts are properly secured.
FITTING THE AIR HOSE
Make sure that the air pipe end connectors are
well fastened to the hose itself, if necessary
rotate counterclockwise.
Insert the end of the tube with bayonet plug into
the body of the appliance (Fig C1) and the other
to the gun (Fig. C2).
FITTING THE TRANSPORT BELT (4 Fig.A)
Attach the strap terminals to the front and rear
seats of the body.
Check the presence of the paint suction tube
inside the tank (19 Fig.A) and push it slightly
upwards to make sure it is securely attached
to the gun body.
