Loading media
Compa II series
30 Operating
manual
07.15
1. Turn lever (5) counter clockwise to lift up the printhead.
2. Push label guiding on deviating shaft (4) all the way out.
3. Guide label material below the deviating shaft (4) and the label
photocell so it leaves the print unit between printhead and print
roller.
4. Push label guiding on deviating shaft (4) against the outer edge of
the label material.
Figure 10
The label sensor (2) can be shifted perpendicular to the direction of
paper flow for adaptation to the label medium. The sensor unit (1) of
the label sensor is visible from the front through the print unit and is
marked with an indentation in the label sensor retainer.
Position label sensor with tab (3) in such a way that the sensor
(1) can detect the label gap or a reflex or perforation mark.
If the labels deviate from a rectangular shape:
Align label sensor using the tab (3) with the front edge of the
label in the direction of paper flow.
For use in tear-off mode only:
Turn red lever clockwise to lock the printhead.
Inserting label material
into print unit
Setting label photocell
