RE856
OPERATION MANUAL
AUS
1300 734 253 NZ 0800 734 253
18
MAINTENANCE
Cleaning
Repairs or servicing are not covered in this operation manual and should only be performed by qualified personnel. Please
return the meter to VALEN if this is the case.
Periodically wipe the case with a dry cloth. Do not use abrasives or solvents on this instrument.
Battery Check and Replacement
If the battery power is not sufficient, the symbol will be shown on display. Replacement of six new 1.5V alkaline AA
batteries is required.
Prevention of Battery Fluid Leakage
When the battery power is low, replace the new batteries to avoid further battery fluid leakage possibility.
When the meter will not be in use for an extended period of time, please remove the batteries out of the meter to prevent
the possibility of battery fluid leakage damage.
SOFTWARE
Hardware Requirements and Setup
PC Hardware Requirements
HDD, CD Rom, 486PC or above, with available COM port/USB port
EGA or higher
4M bytes or more memory size
PC Hardware Setup
1.
Switch off all power related to the PC.
2.
Connect the USB cable to an available port.
3.
Switch on all related power.
4.
Connect the optical plug end of the supplied cable to the meter.
Software Requirements and Setup
1.
Start up Windows operating system.
2.
Close all other applications.
3.
Insert the disk into the CD drive.
(if autorun does not start, open the CD drive then run ‘Install\setup’)
4.
Follow the onscreen instructions:
a.
b.
