Valcourt DALLAIRE FP18, Инструкция по установке и эксплуатации

Страница: 26 / 70

Page 26
Installation and Operation Manual - FP18 Dallaire
ENGLISH
To remove or replace the glass (G) :
1. Remove the door (H) and place it face-down on something soft.
2. Remove the glass retainers (E) held in place by the screws (D) .
3. Remove the frames (F) .
4. Remove the glass. If it is damaged install a new one in place. The
replacement glass must have a gasket all around.
5. Reinstall the glass, being careful to centre the glass in the door and not
to over-tightening the retaining screw.
The two main causes of broken door glass are uneven placement in the
door and over-tightening the retaining screws.
6.3.3 Gasket
The glass gasket is flat, adhesive-backed, woven fibreglass. The gasket
must be centred on the edge of the glass.
1. Follow the steps of the previous section to remove the glass.
2. Remove the old gasket and clean the glass thoroughly.
3. Peel back a section of the paper covering the adhesive and place the gasket on a table with the
adhesive side up.
4. Stick the end of the gasket to the middle of one edge, then press the edge of the glass down onto
the gasket, taking care that it is perfectly centred on the gasket.
5. Peel off more of the backing and rotate the glass. The gasket must not be stretched during
installation.
6. Cut the gasket to the required length. Pinch the gasket onto the glass in a U-shape, all around
the glass.