3
Mounting
The V-2001A was designed for wall or table
mounting. Secure unit to wall studs or a suitable
brace away from heat sources or strong
magnetic fields (Motors, fans, power supplies,
etc.) with the control and terminal strip
accessible. Four wood screws are included for
mounting.
Power Connections
NOTE: This equipment must be installed
near an AC power outlet due to the power
cord being used as a disconnect device.
•
The V-2001A is provided with a NEMA 5-15
cord set for North American use.
•
Connect cord set to unit via IEC 320 female
connector located on one end of cord set to
IEC 320 male appliance coupler located on
the V-2001A.
•
For 115VAC use, verify fuse rating of 1 Amp
and voltage selector switch displays 115V.
•
For 230VAC use, verify fuse rating of 0.5
Amp and voltage selector switch displays
230V.
After all required connections
have been made, plug the cord
set into appropriate AC wall
outlet.
CONNECTIONS
Refer to Figure 1.
Electronic Key or PABX Access
When using the V-2001A with an electronic key
system, C. O. line position or PABX trunk port,
the battery feed switch (SW1) must be ON.
Pre-Page Alert Tone Option
The Pre-Page Alert Tone may be used when
accessing the unit from an electronic key
system, C. O. Line position, PABX Trunk Port or
a Page Port with a contact closure. Page Ports
must provide a contact closure output. To
enable the pre-page alert tone feature, place a
jumper on the yellow and black leads (outer pair
of RJ-11) of J3. (See Figure 1).
NOTE: The pre-page alert tone operates on
the primary paging input only.
Operation
: Press line key (Electronic key
system) or dial trunk access code (PABX) to
connect to the paging speakers. Make
announcement. The V-2001A automatically
disconnects from page.
Page Port Access
When accessing the V-2001A from a telephone
system page port, the battery feed switch (SW1)
must be OFF.
Operation
:
Follow the telephone system
manufacturer's instructions for access to
external paging. Make announcement. The
V-2001A automatically disconnects from page
.
The V-2001A voice switching circuit is activated
when the person making the page begins to
speak. When the page is completed or the
person stops speaking for more than two
seconds, the paging circuit turns off. Other
functions of the unit remain the same.
Background Music
Background music may be connected to the
V-2001A when using either access method.
Background music mutes on the "page + music"
outputs when a page is made.
Connect the output of a low level music source
to the screw terminals marked "Music" on the
input terminal strip on the V-2001A. Adjust
music volume control on the V-2001A to the
desired level.
Night Ring and Single Tones
Night ringing (Electronic warble tone) over
paging is activated by a common audible
contact closure or 90VAC ring voltage.
A single tone (Time clock) over paging is
provided when the V-2001A is connected to a
contact closure.
Tone Options
SW4 enables or disables single and warble
tones on all page outputs. SW2 enables or
disables single tones and warble tones on the
page without music output only.
