background image

 

1                                                                                       947051 

CAUTION:  To reduce the risk of electric shock,

Do not remove cover.

No user serviceable parts inside.

Refer servicing to qualified service personnel.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This symbol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.

This symbol indicates that there are
important operating and maintenance
instructions in the literature accompanying
this unit.

ISSUE 3

 

VIP-800 

NETWORKED PAGING ZONE EXTENDER 

 
 

INTRODUCTION 

The VIP-800 enables voice access to a single zone of 
one-way paging over an IP-based LAN/WAN. This will 
allow page zone extension anywhere on the network. 

 

SPECIFICATIONS 

Access Methods

 

  PBX (VIP-820 connected to a analog station port) 

  VIP-810 plus POTS phone set 

  600 Ohm Supervised Page Port 

  Any of Valcom’s distributed amplified one-way 

     Page Controls (V-2003A, V-2006A,V-2924A) 

 

Features 

  RJ-45 for network connection 

  Front panel activity LED 

  Network activity LED’s on RJ-45 

  Provides audio for up to 150 Valcom one-way 

     amplified speaker assemblies  

  Background music input 

  Contact closure or VOX operation of input  

  Removable screw terminal connectors provided 

     for both inputs and outputs 

  Page with music output, music mutes during page 

 Output 

control 

contact 

closure provided during 

     paging output 

  May be used with 25 or 70 Volt amplifiers 

  2.5mm jack for DC power (115VAC TO 24VDC 

     adapter provided) 

 

NOTE

:  Even after assigning a static ID address 

the unit will not respond to a “Ping” test.  

 

Dimensions/Weight 

  1.88" H x 5.50" W x 4.15" D  

(4.78cm H x 13.97cm W x 10.54cm D) 

  Weight:   0.55 lbs.  (0.25 kg) 

 

Nominal Specifications

 

Input Impedance: 

600 Ohms 

Input Level: 

-10dBm nominal 

Voice Switch Sensitivity: 

-21dBm

 

Music Source Input Impedance: 

8 to 600 Ohms 

Music Input Level: 

-10dBm nominal 

Output Impedance: 

8 Ohms 

Output Level: 

- 10dBm nominal 

 

Nominal Power Requirements

 

Voltage:   

 

 

 

  24VDC  

Current:   

 

 

 

  325mA

 

         

 

 
 
 

 
Environment

 

Temperature: 

                          0 to +40 Degrees C 

Humidity:     

               0 to 85% non-precipitating 

 

INSTALLATION 

NOTE:  The telephone system referred to in this 
manual is the customer premise equipment such 
as an electronic key system, a PBX or a dedicated 
single line telephone(s). The VIP-800 is not 
intended for direct or indirect connection to the 
public telephone network.  When used with a 
customer premise telephone system such as a 
key system or PBX system, these units are 
interfaced to the system via a fully protected page 
port or system central office port, which is a fully 
protected interface device.  Also, the host system 
must be configured to disallow central office 
trunk conferencing in order to prevent indirect 
connection to the public network. 

 

          Precautionary Designations 

 
 
 
 
 
 
 
 
 
 

 

 

 

Mounting

 

The VIP-800 was designed for wall or table mounting.  
Secure unit to wall studs or a suitable brace away 
from heat sources or strong magnetic fields (motors, 
fans, power supplies, etc.) with the control and 
terminal strip accessible.  One wood screw is included 
for mounting. 

Отзывы: