Valcom IP bold series, Инструкция по установке и эксплуатации

Страница: 44 / 79

IP BOLD
- installation and operating instructions
44
and synchronization delay 7 sec. Codes for relay 1 closing are 55 and
56. The relay 4 we setup as monostable, closing time 1 sec, closing
code 55.
By synchronization you can create different closing combination.
Synchronization delay
– time between synchronization start and its
evaluation. Usage for example in more relays closing combination for
one code
Activation during call
– options are
none (calling has no influence for relay status)
incoming call
– relay closed during incoming call. The monostable for
preprogrammed time. The bistable permanently for all call duration.
outgoing call
– relay closed during outgoing call. The monostable for
preprogrammed time. The bistable permanently for all call duration.
Incoming as same as outgoing call
– relay closed during every call.
The monostable for preprogrammed time. The bistable permanently
for all call duration.
Acoustical signal
– In case of need you can simulate relay closing by sound
signal. This feature is usefull mainly in monostable mode in case of
PoE feeding of low consumption electrical lock by DC power supply.
This sound simulates typical buzzing of electrical lock. Further option
is record voice message to SD card for blind people with information
about electrical lock opening.
This option has yet another hidden meaning, the LED on the front
panel when you turn the acoustic signal indicates the switch is
activated lights red + green.
Activation during LAN failure
– this is security action when network
connection fail it is not possible close relay for example by code from
buttons. Application is there where is monitor when was used which
code and this record during LAN failure will not be performed.
Activate by protocol HTTP
– relay status is possible change by sending
HTTP request (GET request) to IP adress of door entry. To get
working this feature you must permit by parametr relay control by
HTTP. Request for door entry must be in following format (you can
test by variol web browser):
command relay switch:
IPaddress / relay_control? R = on where r = number of relays 1-4
E.g. http://192.168.1.250/relay_control?1=on - switches on relay 1
(doorphone to the default IP address)
command to releasing relay:
IPaddress / relay_control? R = off where r = number of relays 1-4
E.g. http://192.168.1.250/relay_control?1=off - switches off relay 1
(doorphone to the default IP address). Releasing the relay is
important in the bistable switch mode.