stroller AsseMBlY/oPeNING
FIGURE A - ASSEMBLING YOUR STROLLER
1. Remove the carton contents carefully. Dispose of any
packaging materials thoughtfully.
2. Release the stroller from the locked position by lifting the
locking hinge from over the locking rivet on the stroller
frame. HINT: You may need to squeeze the stroller legs
and handles closer together first so as to release the
tension on the rivet.
FIGURE B - ASSEMBLING YOUR STROLLER
3. Standing behind the stroller and holding it by the
handles, allow the wheels to fall forward.
4. With your foot, press down on both primary locking
hinges until the entire frame locks into the open position.
IMPortANt WArNING: AlWAYs test tHAt All lAtCHes Are
seCUrelY eNGAGeD BeFore Use.
FIGURE C - CONNECTING THE FRONT WHEELS
Note: tHe reAr WHeels CoMe AttACHeD to YoUr stroller AND
reQUIre No AsseMBlY
5.
Single Front Side Wheels:
Insert the front swivel wheel
pin into the housing on the front leg and push upward
until you feel it lock into place. Repeat for the other
wheel.
6. To fix the front wheels in the non swivel position, slide
the latch on the front of the each wheel housing to the
outside and turn the wheel until it locks into place.
7. To unlock, slide the latch on the front of each wheel
housing to the inside.
8.
Double Front Centre Wheel:
Insert the centre front
swivel wheel over the housing on the front leg and push
upward until you feel it lock into place.
Be sure to insert
wheel (underneath the pram), in the direction of the
arrrow, with the lock at the top.
9. To fix the front wheels in the non swivel position, turn the
wheel so that the two notches on both housings line up.
10. Lift the swivel lock until it locks into place. To unlock,
press down firmly on the red swivel lock to release.
FIGURE D - ATTACHING THE HOOD
11. Slide the hood fixture into the corresponding housing
on the sides of the stroller frame
11. Snap the center hood connector to the centre bar of the
stroller frame.
12. Secure the rear of each hood to the frame by wrapping
and securing the Velcro strap around the frame.
13. Repeat for the other side.
14. Arrange the rear hood skirt beneath and around
each seat back and secure the snaps to the
corresponding snaps found on the back of each
seat.
A
B
C
D
FRONT
SIDE
WHEELS
FRONT
CENTRE
WHEEL
CLICK
HOOD
SIDES
HOOD
CENTRE
VELCRO
ATTACH
