VALBERG WF 814 S566C, Инструкция по эксплуатации

Страница: 5 / 65

6 7 EN EN
Using the appliance Using the appliance
B B
Remove the transport bolts
Levelling the washing machine
Connect the water supply hose
Drain Hose
WARNING!
You must remove the transport bolts from the back side before using the product.
WARNING!
The lock nuts on all four feet must be screwed tightly against the housing.
WARNING!
To prevent leakage or water damage, follow the instructions in this chapter
• Do not kink, crush or modify the water inlet hose.
WARNING!
• Do not kink or stretch the drain hose.
• Position the drain hose properly, otherwise damage might result or water leakage.
1 2 3
n
Loosen the 4 transport bolts with a spanner.
o
Remove the bolts including the rubber parts and keep them for future use.
p
Close the holes using the cover caps.
n
Loosen the lock nut.
o
Turn the foot until it reaches the floor.
p
Adjust the legs and lock the nuts with a spanner. Make sure the machine is level and
steady.
n
Put it into the water trough.
o
Connect it to the branch drain pipe of the trough.
Connect the water supply hose to the water inlet valve and a water tap with cold water as
indicated.
There are two ways to place the end of the drain hose:
NOTE
Connect manually, do not use tools. Check if the connections are tight.
Water
trough
Max.100cm Max.100cm
Max.100cm
Min.60cm Min.60cm
1 2