VALBERG CNF 270 F W625C2, Инструкция по эксплуатации

Страница: 5 / 40

6 7
B B
6 7
When using the appliance When using the appliance
B B
• This appliance must be installed so that the plug is always accessible. Make sure, after
installing it, that it is not resting on the power cable.
• Level the appliance using the 2 adjustable feet.
Connection to the mains
Your appliance is designed to operate under a single-phase voltage of 230 volts. It must be
connected to an earthed outlet and protected by a fuse. The electrical installation must comply
with the requirements of standard NF C 15-100.
Door
• You can change the opening direction of the door of your appliance by moving the hinges.
When reassembling, make sure that the door is aligned with the body and that the seal
adheres correctly.
• We remind you that changing the direction of the door opening must be done when the
appliance is unplugged.
• Before laying the refrigerator on its back to gain access to the base, place it on foam or similar
material, in order to avoid damaging the cooling circuit located at the back of the refrigerator.
• Remove the hinge cover Loosen the screws used for fixing the upper right hinge of the door.
Top hinge
left
Self-tapping
screws with
special flange
• Remove the rod from the top hinge, position it on the other side and tighten it firmly.
• Lift the lower door and place it on a surface that will not damage it.
• Loosen the screw that fixes the door stopper and install it on the left side.
NOTE : When removing the door, make sure you do
not lose the washer between the centre hinge and the
bottom of the freezer door.
• Loosen the screws that secure the central hinge, then remove the central hinge that holds
the lower door in place.
Central
hinge
Screw securing the
central hinge
• Lift the lower door and place it on a surface that will not damage it.
• Remove the screw covers from the left central hinge and place them over the open holes
on the right side.
Screw cover
Screw cover
Screw cover
Screw cover
• Lay the refrigerator on foam or similar material, in order to avoid damaging the cooling
circuit located at the back of the refrigerator.
• Remove the two lower adjustable feet, then remove the mounting plate and lower hinge.
Mounting
plate on the
front foot
Adjustable
lower foot
Screw securing
the front foot
plate
Bottom
hinge
Adjustable
lower foot
Screw securing
the front foot
plate
EN EN