VALBERG 972652, Инструкция по эксплуатации

Страница: 9 / 162

6 EN
Using the appliance
B
Water inlet hose
The appliance must be connected to the water supply network using
the new connection sets supplied with the appliance; used connection
sets must not be reused.
Before connecting the new or water inlet hose, or one that has not been
used for a long time, to your dishwasher, run water through it for a
while. Manually connect the water inlet hose directly to the inlet tap.
The pressure at the tap must be a minimum of 0.03 Mpa and a maximum
of 1 Mpa. If the water pressure is greater than 1 Mpa, install a pressure
reducing device between the tap and the pipe. Once the connections
are made, open the valve completely and check that there are no leaks.
For your safety, always close the inlet tap after each programme. Check the marking on the
water inlet hose! If the hose is marked 25°C, the water temperature must be a maximum of
25°C (cold water).
For all other models: Preferably cold water; hot water with a maximum temperature of 60°C.
N.B.
S o m e m o d e l s u s e a n A q u a s t o p s y s t e m .
If your dishwasher is equipped with this option, there
is a dangerous voltage. Never cut the Aquastop nozzle
and make sure that it is not bent or twisted.