VALBERG 6S47 D SAD929C, Инструкция по эксплуатации, Страница: 32 / 141

31 EN
Troubleshooting tips
Before calling for service
Reviewing the charts on the following pages may save you from calling for service
Problem Possible Causes Solution
Dishwasher
doesn’t start
• Fuse blown, or
the circuit breaker
tripped.
• Power supply is not
turned on.
• Door of dishwasher
not properly closed.
• Replace fuse or reset circuit breaker.
• Remove any other appliances sharing
the same circuit with the dishwasher.
• Make sure the dishwasher is turned
on and the door is closed securely.
• Make sure the power cord is properly
plugged into the wall socket.
• Make sure to close the door property
and latch it.
Water not pumped
from dishwasher
• Kink in drain hose
• Filter clogged.
• Kitchen sink
clogged.
• Check drain hose.
• Check the coarse filter. (see section
titled «Internal Care»)
• Check the kitchen sink to make sure
it is draining well. If the problem is
the kitchen sink that is not draining,
you may need a plumber rather than
a serviceman for dishwashers.
Foam in the tub • Improper detergent.
• Spilled rinse aid.
• Use only the special dishwasher
detergent to avoid suds. If this
occurred, open the dishwasher and
let suds evaporate. Add 1 gallon of
cold water to the tub. Close and latch
the dishwasher, then Start any wash
cycle to drain out the water.
•
• Repeat if necessary.
• Always wipe up rinse aid spills
immediately.
Stained tub interior • Detergent with
colourant may have
been used.
• Make sure that the detergent has no
colourant.
Cleaning and maintenance
C