Val-Tex Easy Lube 40-70, Руководство по эксплуатации

Страница: 32 / 41

High-Pressure Stripped Pump SER 331378-A1
Alemite Corporation 9 Revision (2-98)
9
33
25
26
27
28
6
34
31
32
35
Air Motor Rod
6
4
8
5
7
21
22
15
13
14
10
9
11
16
17
6
19
12
18
23
30
Detail A
24
A
29
20
Figure 5 Pump Tubes 337384-A1, B1, C1, F1, and G1 - Section View
9. Screw Rod (10) into Coupling (11)
until the pin holes align.
• Install Pin (9).
10. Screw Coupling (7) [center hole first]
onto the Rod until the pin holes align.
• Install additional Pin (9).
11. Secure the air motor assembly in a
soft-jaw vise.
12. Screw the Coupling assembly onto
the air motor rod until the pin holes
align.
• Install Pin (8).
Pump Tube (Outer Components)
13. Install and seat Seal (21) [lips first]
into the bottom of Retainer (20). See
Figure 2.
14. Install and seat Bearing (22) into the
bottom of the Retainer.
15. Install Gasket (23) onto the top of
Extension (24).
16. Screw the Extension (Gasket end
first) into the bottom of the Retainer.
• Do not tighten at this time.
17. Install Gasket (6) into the top of the
Retainer.
18. Install and seat Bearing (19) [small
diameter first] and additional Gasket
(6) into the top of the Retainer.
19. Screw Tube (18) into the top of the
Retainer.
• Do not tighten at this time.
20. Install and seat Gasket (6) into
Adapter (5).
IMPORTANT: If a primer is
used with Loctite 222, the
c u r i n g t i m e i s g r e a t l y
reduced.
21. Screw the Tube assembly [with
Loctite 222] into the Adapter.
• Follow the thread sealant
manufacturer’s recommendations.
• Do not tighten at this time.
22. Install O-Ring (4) onto the Adapter.
Refer to Figure 2 Parts List
for Parts Identification