
22
Split Murales User Manual
12 Storage over a prolonged Period
If you do not intend to use the unit over a period of
time:
• Put the fan into operation for three or four hours in
order to dry the inside of the unit.
• Stop the unit and disconnect the thermal magnetic
switch.
• Clean the air filters.
Remove the batteries from the remote controller.
Before turning the unit back on:
• Position the remote controller batteries.
• Check that the air filters are not blocked.
• Check that the air outlet and inlet are not blocked.
• Check that the thermal magnetic switch is connected.
Danger of injury and physical damage!
In the event that the equipment is removed and
reinstalled at a later date, ensure that the
equipment is properly installed by personnel
with the appropriate qualifications (see manual
for installer). Otherwise water leakage,
refrigerant leakage, short circuiting or even fire
could be caused.
13 Product Decommissioning
Danger of injury and physical damage!
When disposing of the product, ensure that the
necessary precautions are taken. In order to do
so follow the steps described in the installation
manual in reverse order and use the necessary
tools and protection resources.
Ensure that the disassembly is carried out by
qualified, technically competent individuals.
Warning!
Danger of environmental contamination when
disposing of the unit. To avoid this, follow the
instructions described in this section.
Fig. 12.1 Recycling symbol.
Your product is marked with the recycling symbol (see
Figure 12.1), which means that the following must be
taken into account during the disposal:
• Do not mix the unit with other domestic, unclassified
waste.
• Dispose of the equipment in accordance with the
relevant local and national standards, correctly and in
an environmentally-friendly way.
• Hand in the unit to a waste management company
that is authorised by the local authorities to transport
it to a proper treatment plant.
• If the product is being replaced with a new product
destined for the same use, hand in the old product to
the distributor of the new unit for waste management
as appropriate.
• Contact local authorities for more information.
12 Storage over a prolonged Period
13 Product Decommissioning