11
Split wall-mounted User Manual
EN
7.9.2 TIMER Function (CONNECTION USING TIMER)
The unit can be automatically connected/disconnected
using the timer.
Note!
Before starting, make sure that the clock is
adjusted correctly.
In order to set the unit to disconnect automatically:
With the unit connected (see section 7.4):
• Press the TIMER button.
The timer settings range from 1 to 24 hours. Each time
the TIMER button is pressed the sequence will be as
follows: 1 - 2 - ... up to 24 and cancel (no indication). If
you continue pressing it starts counting all over again
• The selected time will be shown on the remote
controller display. During the countdown process the
display will always show the remaining time.
In order to set the unit to connect automatically:
Note!
The automatic connection can only be made with
the unit switched off.
• Press the OFF button.
• Press the TIMER button.
The timer settings range from 1 to 24 hours. Each time
the TIMER buttion is pressed the sequence will be as
follows: 1 - 2 - ... up to 24 and cancel (no indication). If
you continue pressing it starts counting all over again
• The selected time will be shown on the remote
controller display. During the countdown process the
display will always show the remaining time.
In order to cancel the TIMER mode:
• Press the TIMER button until 24 appears on display.
Press the TIMER button once more to cancel this
mode.
Note!
Restart the time configuration after replacing
the batteries or after a possible power failure.
7.10 Indicators of the unit
Fig. 7.8 Overview of the display in the indoor unit.
Legend
1 TURBO indicator
2 TIMER indicator
3 ON/OFF indicator
4 TEMPERATURE indicator
Operating Instructions 7
