Set-up 4
0020265768_01 eloBLOCK Installation and maintenance instructions
7
4.3
Minimum clearances
A
A
B
D
C
A
50 mm
B
500 mm
C
800 mm
D
700 mm
4.4
Requirements for the installation site
▶
Only install the product indoors.
▶
Select the installation site so that the pipes can be routed
appropriately (water supply and drain).
▶
Do not install the product close to stairways, emergency
exits or air-conditioning systems.
▶
Do not install the product above an appliance the use of
which may damage the product (e.g. above a cooker that
may emit grease vapours).
▶
Do not install the product in areas in which water can
penetrate the product.
▶
Do not install the product in rooms prone to frost.
4.4.1
Observing the restrictions in damp rooms
1
2
3
3
2
0
1
A
A
A
0
Zone 0
1
Zone 1
2
Zone 2
3
Zone 3
A
60 cm
▶
Install the product in bathrooms, washrooms and shower
rooms outside of zones 0, 1 and 2.
▶
If water can penetrate the product, do not install the
product in zone 3 either.
4.5
Wall-mounting the product
1.
Check whether the wall has sufficient load-bearing ca-
pacity to bear the operational weight of the product.
2.
Check if the supplied fixing material may be used for
the wall.
Condition
: The load-bearing capacity of the wall is sufficient, The fixing
material may be used for the wall
▶
Wall-mount the product.
Condition
: The load-bearing capacity of the wall is not sufficient
▶
Ensure that wall-mounting apparatus on-site has a suf-
ficient load-bearing capacity. Use individual stands or
primary walling, for example.
▶
Do not wall-mount the product if you cannot provide
wall-mounting apparatus with a sufficient load-bearing
capacity.
Condition
: The fixing material may not be used for the wall
▶
Wall-mount the product using the permitted fixing mater-
ial provided on-site.
4.5.1
Wall-mounting the product with the product
bracket
B
A
1
2
3
4
1.
Place the product bracket
(1)
on the wall and mark the
three holes.
2.
Put the product bracket to one side and drill the holes in
the wall.
3.
Use the enclosed rawl plugs and screws
(2)
to fix the
product bracket to the wall.
4.
Hang the product in the product bracket from above.
