Vaillant ecoTEC plus VU GB 5-5 Series, Инструкция по установке и обслуживанию

Страница: 48 / 60

Appendix
48
Installation and maintenance instructions ecoTEC plus 0020134823_07
Yes No Values Unit
Motorised flue non-return flaps wired correctly?
D.027 / D.028 (switching of relay 2) to 4 (= extraction
hood) set?
D.090 (eBus control) detected?
Condensate delivery pump (if required): Fault message
cable connected to each product?
Other heat generators
Solar system, heat pump, solid fuel boiler?
If yes, which type?
Control system
Vaillant control
If yes, which type?
Third-party control
If yes, which type?
Room temperature control, outdoor temperature control
If yes, which type?
Heating demand from which control?
Domestic hot water demand from control (in-
ternal/external)
Sensor positioned correctly and connected?
vrnetDIALOG installed correctly, signal available?
Start-up/default settings
CO
₂
content at max. via P.1 (before adjustment) Vol.%
CO
₂
content at max. via P.1 (after adjustment) Vol.%
Gas flow pressure at nominal heat loading (max. output
for cascades) kPa (mbar)
CO
₂
content at min. via P.2 Vol.%
Gas volume flow at P
max
via P.1 (if possible) m
³
/min
Gas volume flow at P
min
via P.2 (if possible) m
³
/min
Primary circuit water sample mol/m
³
or mg/l
CaCO
₃
Secondary circuit water sample mol/m
³
or mg/l
CaCO
₃
Heating circuit system pressure MPa (bar)
Default settings
Partial heating load via D.000 kW
Pump overrun via D.001 min
Max. burner anti-cycling time via D.002 min
Max. cylinder charging output via D.077 kW