Vaillant eco TEC plus 415, Инструкция по эксплуатации

Страница: 6 / 172

Installation and Servicing ecoTEC plus
6
1.4.13 Protection against freezing
The boiler has a built in frost protection programme as
long as the electricity and gas are left switched on.
This device operates the burner and system pump
when the temperature inside the boiler falls to 3°C.
Any other exposed areas of the system should be
protected by a separate frost thermostat.
If the mains electricity and gas are to be turned off for
any long periods during severe weather, it is
recommended that the whole system, including the
boiler, should be drained to avoid the risk of freezing.
Make sure that, if fitted, the immersion heater in the
cylinder is switched off.
If you have a sealed water system contact your
installation/ servicing company as draining, refilling
and pressurising MUST be carried out by a competent
person.
As a safety feature the boiler will stop working if the
condensate drain becomes blocked. During freezing
conditions this may be due to the forming of ice in the
condense drain external to the house. Release an ice
blockage by the use of warm cloths on the pipe. The
boiler should then restart. Contact your installation/
servicing company if the fault persists.
1.4.14 Boilers installed in a compartment or
cupboard
If the boiler is fitted into a compartment or cupboard it
does not require ventilation openings.
Do not use the compartment or cupboard for storage.
1.4.15 Boiler casing
Do not remove or adjust the casing in any way, as
incorrect-fitting may result in incorrect operation or
failure to operate at all.
1.4.16 Condensate drain
The condensate drain must not be modified or blocked.
1.4 .17 Pluming from flue terminal
All condensing boilers produce a plume of water
vapour from the flue terminal. This is due to the
high efficiency and hence low flue gas temperature.
This may increase in wet, damp weather but this is
completely normal and indicates that the boiler is
operating correctly.
1.4.18 Cleaning
This appliance contains metal parts and care should
be taken when handling and cleaning with particular
regard to edges.
The boiler casing can be cleaned using a mild liquid
detergent with a damp cloth, then a dry cloth to polish.
Do not use any form of abrasive or solvent cleaner as
you may damage the paint work.
1.4.19 Maintenance and servicing
For the continued efficient and safe operation of the
boiler it is recommended that it is checked and
serviced at regular intervals. The frequency of
servicing will depend upon the installation conditions
and usage, but in general, once a year should be
enough.
If this appliance is installed in a rented property there
is a duty of care imposed on the owner of the property
by the current issue of the Gas Safety (Installation and
Use) Regulations, Section 35.
Servicing/maintenance should be carried out by a
competent person in accordance with the rules in force
in the countries of destination.
To obtain service, please call your installer or Vaillant
Service Solutions (0870 6060 777).
Please be advised that the installation engineer on
completion of commissioning and servicing should
complete the ‘Benchmark’ logbook.
All CORGI Registered Installers carry a CORGI ID
card, and have a registration number. Both should be
recorded in your boiler Logbook. You can check your
installer is CORGI registered by calling CORGI direct
on: - 01256 372300.
1.4.20 Technical data
Al dimensions are given in millimetres (except as
noted). The data label is positioned on the combustion
chamber cover. The Seasonal Efficiency Domestic
Boilers UK (SEDBUK) is:
All ecoTEC plus boilers : Class ‘A’.
The value is used in the UK Government’s Standard
Assessment Procedure (SAP) for energy rating of
dwellings. The test data from which it has been
calculated has been certified by B.S.I.
1.4.21 Guarantee
Vaillant provide a full two year parts and labour
warranty for your appliance.
The appliance must be installed by a suitably
competent person in accordance with the gas
safety (installation and Use) Regulations 1998, and
the manufacture's instructions. In the UK ‘CORGI’
registered installers undertake the work in compliance
with safe and satisfactory standards.
Terms and conditions apply to the warranty, details of
which can be found on the warranty registration card
included with this appliance.
Failure to install and commission this appliance in
compliance with the manufacture's instructions may
invalidate the warranty (this does not affect your
statutory rights).
1 Introduction
Supplied by HeatingSpares247.com