On-roof fitting and installation 4
0020159946_01 auroTHERM classic Installation manual
11
A
2
1
B
5 mm
2.
Secure the type P roof bracket either to the rafters
(A)
or to the roof batten
(B)
.
3.
To do this, loosen the bolt
(1)
on the base of the roof
bracket with the enclosed bit and unscrew the bolt by
approx. 5 mm.
4.
If you wish to secure the roof bracket onto the rafters,
turn the base
(2)
outwards
(A)
.
5.
If you wish to secure the roof bracket onto the roof bat-
ten, turn the base
(2)
inwards
(B)
.
Conditions
: Fastening type: To rafters
1
2
▶
Define the clearances of the roof brackets. (
→
Page 10)
▶
Expose the rafters at the corresponding position
(1)
.
▶
Position the roof bracket
(2)
. Ensure the correct position
of the top, middle and lower roof brackets.
3
4
▶
Undo the top bolt until the height of the roof bracket can
be adjusted
(3)
.
–
Working materials: SW 13 spanner
▶
Adjust the roof bracket to the height of the pantiles, so
that the top part of the roof bracket lies on the roofing
(4)
.
▶
Tighten the top bolt.
–
Working materials: SW 13 spanner
5
6
A
B
▶
Screw the roof bracket onto the rafters using the three
bolts supplied
(5)
.
▶
Slide the pantiles into their original position again
(6)
.
▶
To ensure that the tiles lie tightly together, notch gut-
tering onto the underside
(A)
or the top side
(B)
of the
pantile using a hammer, if necessary.
Note
For some roof types, it may be necessary to
offset the roof bracket laterally opposite the
rafters.
To do this, use the "long base" accessory,
article number 0020080177.
Conditions
: Fastening type: To roof batten
1
3
2
▶
Define the clearances of the roof brackets. (
→
Page 10)
▶
Slide one to two pantiles upwards at the corresponding
position above the roof batten
(1)
.
▶
Undo the top bolt until the height of the roof bracket can
be adjusted
(2)
.
–
Working materials: SW 13 spanner
▶
Hang the roof bracket on the roof batten
(3)
. Ensure that
the top, middle and lower roof brackets are positioned
correctly.
