Vaderstad NZ Aggressive NZA 600 Series, Оригинальное руководство пользователя

Страница: 18 / 50

Assembly Instructions
18 11.07.2011
ver. 2
2.7 Fitting the following harrow
The following harrow thills should be screwed into the brackets on the harrow frame or in the
brackets on the rear Crossboard. They can be fitted at two different height positions. In the stand-
ard configuration, the thills should be set in the lower positions. See the figure.
The following harrow sections are hitched onto the thills and locked in place with the screws A.
Note that the screws act as joints, and thus must not be tightened.
When assembling the extensions, see “Figur 2.9”.
2.8 Fitting track eradicators (option)
The track eradicators should be fitted on the front beam or the draw-bar as shown in “Figure 2.10”.
Lateral positioning depends on the tread of the tractor.
NOTE! When folding up the wing section on a harrow with track eradicators on both the centre and
wing sections, it is very likely that the track eradicators will collide if set higher than the harrow
tines. Always make sure the track eradicators do not come into contact with each other when fold-
ing up the harrow.
Figur 2.8 Figur 2.9
Figure 2.10 Figure 2.11
A