WallVIEW PRO 300
WallVIEW PRO 300 Installation and User Guide 341-668 Rev. B Page 3 of 10
The WallVIEW PRO 300 has provisions for daisy chaining control signals when using an RS-232 controller
with only one (1) RS-232 output. Each WallVIEW 300 EZIM has an RS-232 input and an RS-232 output
(Figure 3).
MOUNTING INSTRUCTIONS
Step 1:
After determining the optimum location of the camera system, mark locations for the four screw holes and
cable pass-thru (vertical oval). Install the drywall mounts and cut the hole for the cable pass-thru. At this
point, do not install the Wall Mount.
Step 2:
Connect the 25-pin cable to the EZIM. Next, mount the EZIM and break out cable on the back of the wall
mount, using the two tapped screw holes (see Figure 5).
Step 4:
Take the Wall Mount, with the EZIM and break out cable installed, and place it against the drywall anchors or
3-gang wall box, making sure to pull the Cat. 5 cables through the oval pass-through hole. Finger-tighten the
screws down to the mount and confirm that the base is level. Tighten the screws down firmly. If the bracket
is to be mounted on a 3-gang wall box, use the screws supplied with the electrical box.
Step 5:
Confirm that the Cat. 5 cables are terminated correctly, by testing them with a continuity tester. Next,
connect the break out cables to the appropriate ports on the BRC-300 (VISCA IN cable is labeled). Secure
the camera to the mount and using the ¼”-20 screw.
Figure 3:
Daisy chain control configuration using two (2) WallVIEW PRO 300 systems and a single RS-232 output control
device. See Appendix 1 for wiring and pin-out information.
RS-232 Out
RS-232 Out
RS-232 Input
RS-232 Input
Figure 4:
Thin Profile Wall Mount with oval cable feed-through hole.
The wall mount may be mounted directly to a 3-gang wall
box or to drywall with the appropriate wall anchors.
Figure 5:
25-pin connector mounted to
EZIM (left) and EZIM
mounted to the Wall Mount
(right)
