VADDIO SQUIGGLE BOARD 999-5446-000, Инструкция по установке и эксплуатации

Страница: 6 / 16

Squiggle Board
Squiggle Board Manual 342-0069 Rev. C Page 6 of 16
Installation Notes and Procedures
Before Installing:
•
Locate the whiteboard location paying close attention to whiteboard height requirements, location in the room,
lighting conditions, and checking for in-wall obstructions.
•
Keep other IR or Ultrasonic devices and reflective surfaces away from the whiteboard location.
•
The 4’ x 6’ whiteboard is supplied with 8-clips & screws and the 4’ x 8’ whiteboard is supplied with 10-clips and
screws for mounting purposes, as well as spiral drywall anchors and 8-32 x 1.25” screws.
Step 1: Before installing the Squiggle Board, run the Cat-5e cabling from the equipment head-end to where the
whiteboard is to be installed. Make sure that there is enough excess cable to run to the bottom left corner of the
whiteboard, where the USB extender is located.
Step 2:
Attach the bottom mounting angle clips to the wall with the required wall fasteners at the proper marker
tray height, as specified by the customer, or room requirements.
Note: Vaddio supplies necessary hardware for mounting the whiteboard to standard drywall. Installation
of the whiteboard on masonry or other walls requires specialized mounting screws, available through
construction hardware suppliers. Ensure that all clips/hangers are level, when attaching them to the wall.
Step 3A:
If the Cat-5e is to be run inside the wall cavity (drywall) to the location where the whiteboard is to be
installed, then measure out and drill a hole through the drywall for the Cat-5e to be run through corner below the
Digital Control Panel on the left side of the whiteboard. See the drawing of the Squiggle Board back below for
measurements.