Quick-Connect CCU Z700
Quick-Connect CCU Z700 Installation and User Guide 341-718 Rev. B Page 2 of 12
UNPACKING
Carefully remove and identify the following parts for the Quick-Connect CCU Z700 system:
•
One (1) - Vaddio EZCamera Interface Module CCU (EZIM CCU)
•
One (1) - Vaddio EZIM CCU to HD Break Out cable
•
One (1) - Vaddio Quick-Connect CCU (1-RU Enclosure)
•
One (1) - Vaddio Thin Profile Wall Mount
•
One (1) - EZCamera Control Adapter (RJ-45 to DB-9)
•
One (1) - 36V PowerRite Power Supply with AC Cord Set
•
One (1) - 2-position Phoenix Connector for Tally
•
Mounting
Hardware
•
Documentation
Vaddio
Manual
Wiring Diagram Example:
Figure 2:
The Quick-Connect CCU System uses a Cat. 5 (all 4-pairs) for power to ensure the motors receive the
required current to operate properly. The Video Cat. 5 cable uses all four pairs for video. The RS-232 Cat. 5 provides
communication to the camera for CCU and PTZ control and G/L (where applicable) to the camera. These Cat. 5
cables can be run up to 500’ (152.4m). See Appendix 1 for wiring and pin-out information. NOTE: A direct RS-232
Cat. 5 cable is required for each Quick-Connect CCU and camera. Daisy-Chain configurations are not supported with
Quick-Connect CCU.
CAT-5 Cables
up to 500’
HD Break-out
Cable
EZIM CCU
Power
RS-232
HD & SD (composite) Video on CAT-5
RS-232 Tally
ProductionVIEW™ HD
SD Composite Video to
PreVIEW™ Monitors
HD VIDEO OUT (Y, Pb, Pr)
RS-232 IN
SD VIDEO OUT (SD Mode)
G/L (Not Used)
POWER
Quick-Connect CCU
BRC-Z700 Camera (not included), Wall
Mount with EZIM CCU (behind camera)
Component HD
Composite
Video
+
G
