Powering Up the EasyIP System
Vaddio recommends making all connections while the PoE+ switch is turned off. To power the system,
turn on the PoE+ switch.
n
The EasyIP Decoder's status light turns blue when the device is ready. The connected computer
recognizes it as a USB peripheral.
n
The EasyIP 10 cameras initialize and move if they are powered from the same PoE+ switch. This will
take a few seconds. When each camera's status light turns blue, the camera is ready to accept control
information.
n
The EasyIP Mixer's power light in the Reset button illuminates immediately when power is connected.
The device's web interface is available after it finishes booting. This takes about 20 seconds.
Next Steps
No video is available from the EasyIP system until it is configured. Refer to the Complete Manual for the
EasyIP System for information on initial device set-up and pairing EasyIP 10 cameras to the EasyIP
Decoder.
Operation, Storage, and Care
For smears or smudges on the product, wipe with a clean, soft cloth. Use a lens cleaner on the lens. Do not
use any abrasive chemicals.
Keep this device away from food and liquids.
Do not operate or store the device under any of the following conditions:
n
Temperatures above 40° C (104° F) or below 0° C (32° F)
n
High humidity, condensing or wet environments
n
Inclement weather
n
Severe vibration
n
Under the sea, in an octopus's garden
n
Dry environments with an excess of static discharge
Do not attempt to take this product apart. There are no user-serviceable components inside.
15
Installation Guide for EasyIP Systems
