BaseSTATION
Vaddio BaseSTATION - Document Number 342-0756 Rev A
Page 18 of 40
Screen Shot: Configuration Page
The configuration page allows an administrator to set all the preferences on the STATION. In addition, the page
contains a User Interface replicating functionality of the Dialing Interface on the BaseSTATION Dock. Other controls
include Audio and Video Settings, General Settings, Audio Level and Mute, Video Mute, PIP on/off and position.
1) Call Dialing Interface
: This dialer essentially replicates the dialing interface on the Dock allowing a user to
launch a VoIP call without being in the room.
2) Audio
Controls:
The audio volume controls the audio levels through the monitor speakers. Audio Mute is
provided and will mute the mics in the Dock or the out-going audio only.
3) Video Controls:
This section controls the PIP (picture in picture) on/off and the Video Mute function. Video
Mute stops sending video of the in room participants and will instead send a test pattern or a black screen.
4) Preferences - Audio Settings:
The Audio Settings options include:
a.
Speaker Bass Boost:
EQ filter that enhances the bass response of the monitor speakers.
b.
VoIP TX Boost:
Boosts 3dB gain to the transmitted audio channel for the VoIP function.
c.
USB TX Boost
: Boosts 3dB gain to the USB Record (Microphone Audio) being sent to the PC.
d.
HDMI Audio Input Enable
: Enable or Disables the HDMI audio input for the BaseSTATION Dock. When enabled,
the HDMI audio will be mixed into the Loudspeaker channels (not recommended for conferencing applications).
Note: Don’t forget that the monitor has sound settings too which may add/detract for the audio quality
.
5) Preferences - Video Settings:
The Video Settings options are as follows:
a.
PIP Position
: The PIP Position is selected to be in one of the four (4) corners of the main display.
b.
Video Mute Pattern
: Setting allows the selection between color bars or black screen when a video mute has been
enabled from the user interface panel. Video mute applies to the outgoing USB stream and local display.
c.
HDMI Output Resolution:
The HDMI output resolution from the BaseSTATION Camera Module to the Main
Monitor is set with this parameter. It has a variety of resolutions and frequencies to fit most applications.
d.
Video Input Port:
This allows the selection of the RGBHV or the HDMI as the main video source (like the video
input button on the front panel of the Dock).
6) General
Settings:
LINK Cable Length:
The system allows use with a supplied 25’ (7.62m) or an optional accessory 50’ (15.24m)
Cat-6 SSTP LINK Cable between the Camera and the Dock. To use provided standard 25’ (7.62m) cable, put
this parameter on 25’. If a 50’ (15.24m) cable is used set this parameter to 50’. The cable requirement is
stringent and it is recommended that
ONLY
the Vaddio supplied cables be used…More on this later, again.
Power Mode:
Allows the user to put the system to sleep after an idle period, displaying a status message on
the monitor while the BaseSTATION is dozing.
➊
➍
➌
➋
➎
➏
Содержание BaseStation 999-8920-000
Страница 2: ...BaseSTATION Vaddio BaseSTATION Document Number 342 0756 Rev A Page 2 of 40 Inside Front Cover Blank...
Страница 38: ...BaseSTATION Vaddio BaseSTATION Document Number 342 0756 Rev A Page 38 of 40 System Configuration Notes...
Страница 39: ...BaseSTATION Vaddio BaseSTATION Document Number 342 0756 Rev A Page 39 of 40 Inside Back Cover Blank...
