VADA VFB-S75, Руководство по установке

Страница: 23 / 48

3. If you are using an VFB-APC or VFB-DSU,
you will need to connect the IEC socket
from the pump to the IEC plug cord on
the device, then connect the power chord
to the power point. If you are connecting
directly to a power outlet (without an
VFB-APC or VFB-DSU), connect the
two supplier cords using the IEC socket
and connect to the power chord to the
power point.
Note: Supply voltage that is outside the
limits specified can cause the motor to
overheat leading to overload tripping, reduced
component life or seriously damage pump,
voiding warranty.
4. Ensuring there are no water traces on the
connectors push them firmly into each other.
Note: This connection should be separated
only for servicing and only after the power
supply is removed by unplugging the cord
form the socket outlet.
5. For additional protection, the pump
should use an outlet protected by a
residual current device – RCD (also known
as an Electrical Leakage Circuit breaker
– ELCB) with a maximum rated residual
current of 30Ma.
6. Connect the pump and pressure control
device to the power supply and turn the
power on. The green “Power On” LED will
illuminate.
If you’re using the VFB-S75 with
an APC continue to page 24.
If you’re using the VFB-S75 with
a MSU or DSU continue to page 25.
If you’re installing the VFB-S75 without
these products, your installation is
complete.
ON
23