6
vacon
X
5
OPT
01 115
VAC / Encoder Interface Option Board
24-hour support 1-877-822-6606
The option board is installed just above the control board in all configurations (a Size 1 unit is shown in
Figure 3
for
reference). The screws labeled “A” must be removed from the drive unit; those labeled “B” need only to be loosened
to accept the board slot.
.
Figure 3: Option Mounting Locations
Once the board is in place, tighten the screws to a maximum of 26 in-lbs.
Next, install the flexible circuit to finish the interface to the control board. (Refer to
Figure 4 on page 6
.) To install the
flexible circuit, first remove the keypad frame (necessary in this size unit). The frame is attached with two screws in
opposite corners; the screws thread into fasteners in the plastic assembly. After the flexible circuit is installed,
replace these screws, limiting the installation torque to 12 in-lbs..
Figure 4: Flexible Circuit Interface to Control Board
A
A
B
B
