3.1
Verify that the power cord is disconnected from the power outlet.(As
show in
fig.1)
3.2.
Undo the latches. (fig.2)
3.3.
Lift the power head off the container. (fig.3)
3.4.
Remove the contents from inside the container; make sure you have
all contents as listed. (fig.4)
3.5.
With the power head removed, turn the container upside down. Insert
the feet with casters into the slots and apply pressure into place and secure
them with supplied screw. Do not over- tighten screws. (fig.5)
3.6.
Your vacuum comes ready for dry vacuum cleaning with cartridge
filter pre-installed. If cartridge filter is not installed, refer to page 13 for filter
installation. (fig.6 & 7
）
3.7. Optional, for improved dust bag, fit dust bag flange onto the inlet stub, taking
care not to damage the bag. (fig.8)
3.8.
For wet vacuum cleaning, install the supplied foam filter. If foam filter is
not installed, refer to page 14 for filter installation (fig.9)
3.9.
Place the power head back on the container, and secure into place
using the 2 side latches. (fig.10 & fig.11)
