Removing and Cleaning Cartridge Filter
1
Unlock and remove the filter retainer by tuning retainer handle counter
clockwise.
2
Carefully hold and pull the cartridge filter up for removal. (
fig.6)
3
Clean the cartridge filter by gently tapping or brushing dirt off. Cleaning
should not be done indoors in living areas. For optimal performance a new filter
is recommended.
4
Install cleaned or new filter into place as instructed above in steps 2 and
3 of Installing Cartridge Filter.
5
Wet filters should be removed and allowed to air dry for 24 hours before
installing onto the filter cage.
Installing Foam Filter
9.1.
Verify that the power cord is disconnected from the outlet
9.2.
Remove power head and place in upside down position. Follow instructions
to remove dust filter.
9.3.
Carefully slide foam filter down over the filter cage making sure the whole
cage is covered. (
fig.1 & 2)
9.4.
Replace the power head on to the container.
Cleaning Foam Filter
9.5. With the removed power head in the upside down position, carefully remove
foam filter. (fig.3)
9.6. Use a mild soap and water solution to wash foam filter and rinse with clean
water. (fig.4)
9.7. Allow filter to air dry before installing and using again.
