Vacmaster VK811PH, Руководство пользователя

Страница: 13 / 16

WHEN TO CHANGE FILTERS
Change the collection bag
When the collection bag is 3/4 full, it MUST be replaced. Excessive over filling of this bag makes it
difficult to remove from the vacuum tank and can result in breakage and spills. The collection bag
comes equipped with a quick closing flap. When collection bag becomes 3/4 full, turn off vacuum and
slowly remove the collection bag from the tank until the opening in the collection bag is clear of the
tank. Pull the closure slide up on the collection bag, which will close the opening. Hazardous
materials must be disposed of properly. NEVER throw contaminated debris in your usual trash
receptacle. Place closed collection bag in an OSHA approved poly bag or container marked with
HAZARDOUS MATERIAL warning and dispose in accordance with your local Hazardous Waste
Regulations.
Change the pre-filter
The pre-filter should be replaced with every fifth change of collection bag and whenever there is
damage or a visible collection of debris on the outside of the filter.
Change the HEPA filter
Replace the HEPA filter when loss of vacuum continues to occur after you have checked for an
obstructions in the hose or wand. Also, install a new collection bag and pre-filter.
13
TROUBLESHOOTING
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE
TROUBLESHOOTING.
Symptom
Vacuum will not operate.
Dust comes out from motor cover.
Reduced efficiency and
motor/speed vibration.
Possible Causes
1) No power supply.
2) Faulty power cord.
3) Tank full.
1) The cartridge filter is
missing or damaged.
2) HEPA cartridge filter is not
installed correctly.
1) There is a blockage in the
nozzle, hose, or the container
inlet. The cartridge filter is
clogged by fine dust.
Corrective Action
1) Check power supply – cord,
breakers, fuses.
2) Unplug and check the power
cord. If damaged, have it
repaired by a professional.
3) Empty tank.
1) Attach or replace cartridge
filter.
2) Please make the screw
down to fix the HEPA cartridge
filter.
1) Check nozzle, hose and
container inlets for blockage.
Take off the filter and clean it.
Or install a new cartridge filter.