Vacmaster VK811PH, Руководство пользователя

Страница: 10 / 16

10
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED
‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH FLAMMABLE
GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS
INCLUDE BUT ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS,
OIL-BASE PAINTS, GASOLINE, ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO; COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO
REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM
TOXIC MATERIALS.
WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC
1. Verify that the power cord is disconnected from the outlet. Verify that the tank is clean and
free of dust and dirt. (fig. 1)
2. Remove all filters and dispose of properly.
3. Rinse out the inside of tank to remove any loose debris and dispose of liquid in suitable container.
4. Then carefully install the foam sleeve filter over the filter cage and place the power head back on
the tank. (fig. 2) See filter installing instructions on page 12.
DO NOT USE THE HEPA FILTER FOR LIQUID VACUUMING.
WARNING:
IF FILTERS ARE CONTAMINATED OR HAVE BEEN USED, THEY MUST BE
DISPOSED OF PROPERLY, PRIOR TO PERFORMING WET VACUUMING OPERATIONS.
OPERATING INSTRUCTIONS – WET VACUUMING
1. Fit the desired nozzle to the vacuum hose. (fig. 3)
2. Verify that the switch is in the ‘O’ OFF position before plugging the power cord into the outlet.
(fig. 4)
3. Turn the motor on by turning the switch to the ‘I’ ON position. (fig. 5)
4. After use, empty the tank by unscrewing the drain cap. Drain liquids into a suitable receptacle or
drain. Remember to refit the drain cap to the tank after draining tank. (fig. 6)
IMPORTANT!
When vacuuming large quantities of liquids, do not immerse the nozzle
completely in the liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The machine
LIQUID VACUUM OPERATION
LIQUID VACUUMING
2 3 5
6
1 4