10
IMPORTANT!
Clean or change the cartridge filter regularly for best performance.
ALWAYS USE
CARTRIDGE FILTER FOR DRY VACUUMING
. If the machine is used with out the cartridge filter, the motor
will burn out and the warranty will be voided. Always keep spare filters on-hand.
NOTICE!
The filters included are made of high quality materials designed to stop small dust particles. The
cartridge filter should be used for dry pick-up only. A dry cartridge filter is necessary to pick up dust. If the
cartridge filter is wet, it will clog quickly and be very difficult to clean. Handle the filter carefully when removing
it for cleaning and replacing it. Check the filters for tears or small holes, a small hole can let dust pass through
and out of the cleaner. Do not use a filter with holes or tears, replace it immediately.
WARNING!
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE REMOVING
THE POWER HEAD FROM THE CONTAINER.
Installing Cartridge Filter
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Remove power head and place in upside down position.
3. Install the cartridge filter over the filter cage with the flat end of the filter towards the vacuum power head.
Carefully
push filter in until it stops against the power head. (fig. 2 & 3)
4. Place filter retainer on top of cartridge filter over the raise lip and tighten down by turning retainer
Clockwise, do not over tighten. (fig. 4 & 5)
Removing and Cleaning Cartridge Filter
1. Unlock and remove the filter retainer by tuning retainer handle counter clockwise.
2. Carefully hold and pull the cartridge filter up for removal. (fig. 6)
3. Clean the cartridge filter by gently tapping or brushing dirt off. Cleaning should not be done indoors in
living areas. For optimal performance a new filter is recommended.
4. Install cleaned or new filter into place as instructed above in steps 2 and 3 of Installing Cartridge Filter.
5. Wet filters should be removed and allowed to air dry for 24 hours before installing onto the filter cage.
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Remove power head and place in upside down position. Follow instructions to remove cloth filter.
3. Carefully slide foam sleeve filter down over the filter cage making sure the whole cage is covered.
(fig. 2 & 3)
4. Replace the power head on to the container.
INSTALLING & CLEANING CARTRIDGE FILTER
INSTALLING & CLEANING FOAM SLEEVE FILTER
Содержание VJC1210PF
Страница 12: ...12 EXPLODED VIEW AND PARTS...
