E
N
G
L
IS
H
9
SUBSITUTIVE TRANSMITTER
(Personal Pass system only)
The substitutive transmitter, generated only by means of
WINPPCL, allows to replace by radio a transmitter stored in the
receiver.
A single transmition with the specially programmed
SUBSTITUTIVE TX, nearby the receiver, replaces the transmitter
code with the new one without removing the receiver from the
installation.
Three code substitutions are permitted, if transmitter TX A is
memorised, the options are::
TX B replaces TX A (TX A is no longer operative)
TX C replaces TX B (TX B is no longer operative)
TX D replaces TX C (TX C is no longer operative)
CODE REPLACEMENT
(Royal system only)
The memorized transmitter code can be replaced by a new code
by following the same procedure for the memorization.
In this way the new code will be memorized and the previous
one cancelled.
FULL CODE ERASING
To perform a full code erasing do the following:
• Remove the power to the receiver.
• Press and hold the SW1 key on the receiver.
• At the same time, power-up the receiver.
The receiver LED goes on: release the SW1 key
• The memory spaces are empty and available for a new
programming.
To perform a partial code erasing the PROG2 portable
programmer is required.
RELAY CONTACTS
The contact on the load terminal board is the normally open
type; it is possible to modify the contact to make it work as a
normally closed contact: short-circuit jumper
A
and jumper
B
using tin-based solder and make a sharp cut in the jumper
C
circuit (Fig.2).
ROLLING CODE MODE
(Personal Pass system only)
The receiver manages the rolling code for the Personal Pass
system. This function is disabled by default.
Rolling code mode may be activated by WinPPCL or by using the
SW1 programming button.
•
Press and hold the SW1 key on the receiver:
•
After 4 seconds, LED L1 is turned off
•
After 10 seconds, LED L3 comes on
•
Release the key: LED L3 starts to flash for 5 seconds:
Single flashes
ROLLING CODE disabled
Double flashes
ROLLING CODE enabled
•
To change the settings, press button SW1 within 5 seconds of
the flashing starting; LED L1 will flash in accordance with the
new settings.
•
Wait 5 s from pressing the last button selecting the desired
flashing, LED L1 is turned off and the new configuration is
memorised.
REMOTE RADIO LEARNING
(Personal Pass system only)
This procedure allows to memorize new transmitters by radio, in
sequence and without removing the receiver from the
installation.
The transmitter which allows to enable the programming by
radio must be memorized in advance.
All transmitters programmed by radio will share the same key
configuration as the transmitter which activated the
programming.
Example:
TX A transmitter memorized with the following key configuration:
Key 1 in monostable configuration.
Key 2 in 10 s timer configuration.
Key in bistable configuration.
TX B transmitter to memorize.
• Hold for 5 seconds minimum the keys 1+2 or 1+3 of TX A
• Release both keys
• Press, within 5 seconds, the required key of TX B:
LED L1 on the receiver is turned off and then comes on again
to indicate the code has been memorised correctly
• Within 5 seconds, transmit using the other key on TX B that it
is desired to memorise; repeat this operation for any other
transmitters.
• To exit the self-learning mode wait for at least 5 seconds
The key configuration of TX B transmitter and other
transmitters, set with this procedure, will be the same as
TX A transmitter.
Содержание Wally2-230V
Страница 3: ...Fig 2 ...
