ENGLISH
Programming of the LAST CHANNEL
1.
Hold the MENU key for 5 seconds.
The display shows:
2.
Press the key NEXT or PREVIOUS. The display shows:
3.
Press the MENU key: the display shows the channel currently
set as last (example
99
)
4.
Select the desired channel through the keys NEXT and
PREVIOUS
5.
Press MENU to store: PROG flashes twice to confirm the
programming of the new parameter then the display will
show again
6.
To exit the programming menu wait for 10 seconds without
pressing any key: PROG goes out
ENERGY SAVING mode
ENERGY SAVING mode is activated when the keys are not
operated for at least 10 seconds.
When the ENERGY SAVING mode is active, the display turns off to
save power and turns on when you press any key.
Battery replacement
When the battery low indication blink
, it is necessary to
proceed as soon as possible to replace the batteries; in this
situation there is a significant risk that the controls can not be
sent properly.
Open the battery compartment and replace the two batteries
matching the polarity indicated in the figure.
WARNING:
Batteries contain pollutant elements, must be
disposed of in accordance with environmental regulations
(V2 advise to use a specific disposal system).Transmitter contains
pollutant elements too; follow the same procedure to dispose.
Should the batteries lose electrolytic substances, please replace
them immediately avoiding with care any contact with such
substances.
99/05/CE DIRECTIVE CONFORMITY
The TMU100 transmitters are in conformity with the provisions
of the following EC directive(s), and with the standard referenced
here below:
EN 60950, EN 301 489-1, EN 301 489-3, EN 300 220-2
Racconigi, 20/02/2012
V2 SPA legal representative
Cosimo De Falco
Содержание TMU100
Страница 16: ......
