PROGRAMMING
36
Press the MENU key to confirm, on the
display will appear: LUCi.
If the function is CiCL, on the display will
appear: LUCi.
FLASHLIGHT IN PAUSE
This menu permits to activate or to disactivate
the flashlight during the pause time.
Press the keys UP or DOWN until the display
shows:
Press the MENU key,the display shows one
of the 2 writings:
no
not activated flashlight in pause
Si
activated flashlightin in pause
Press the MENU key,the display shows one
of the 2 writings.
Press the MENU key to confirm, on the
display will appear: LP.PA.
FLASHLIGHT WITH
INTERMITTENCE
The control unit PD2 permits the connection
of a flashlight with or without intermittence.If
the flashlight is equipped with an inner
intermittence effect, it is necessary to select
the option "Si", but if it has no inner
intermittence, it is necessary to select the
option "no" in oder to make it flash.
Press the keys UP or DOWN until the display
shows:
Press the MENU key,the display shows one
of the 2 writings.
no
if the flashlight has no inner
intermittence
Si
the clock function is activated
Set the wished functions pressing the UP or
DOWN keys.
Press the MENU key to confirm, on the
display will appear: in.LP.
CLOCK FUNCTION
This function permits to program the time
bands of opening and closing. It is necessary
to connect a 24h timer with a contact
normally open in parallel with the START
or PEDONAL START input. When the ti-
mer contact is closed, the gate gets into
opening phase and remains opened until the
contact of the timer opens causing the
re-closing of the gate.
IMPORTANT:
FOR A CORRECT
FUNCTIONING IT IS NECESSARY TO
ACTIVATE THE AUTOMATIC CLOSING
(menu Ch.AU.)
Press the keys UP or DOWN until the display
shows:
Press the MENU key,the display shows one
of the 2 writings:
GB
PROGRAMMING
37
no
the clock function is not activated
Si
the clock function is activated
Set the wished functions pressing the UP or
DOWN keys.
Press the MENU key to confirm, on the
display will appear oroL.
BRAKE
This menu enables the activation of the brake
function by which it is possible to avoid
unproper motion of the gate after impulse or
safety intervention ( the gate continues
moving instead of immediately stopping).
This inconvenience occurs when a plate-
clutch motor is employed on a very heavy
gate: because of the inertia, the gate does not
stop immediately but keeps moving for a few
dozens centimetres undermining its safety.
Press UP or DOWN, until the display shows:
Press MENU, the display shows:
no
the brake function is disconnected
Si
the brake function is activated
Press UP or DOWN to select the wished function.
Press MENU to confirm: the display
shows: FrEn.
INPUT STOP
This menu permits to select the functions
associated to the command of STOP.
Press the UP or DOWN keys until on the
display appears:
Press the MENU key,the display shows one
of the 3 writings:
no
the input STOP is not available
ProS
the input STOP stops the gate:
pressing the command START the
gate continues the motion
invE
the command STOP stops the
gate: at the next START the gate
starts moving in the opposite
direction.
NOTE: During the pause STOP stops the
gate: pressing the command START will
always re-closing the gate.
Press UP or Down to select the wished
function.
Press menu to confirm. the display shows
StoP.
INPUT PHOTO 1
The photocell 1 (contact normally closed) is
a safety device which is active during opening
and closing: the intervention of the photocell
during the closing halts the gate, after the
photocell is cleared the gates reverses the
GB
