![background image](http://html.mh-extra.com/html/v-zug/unimatic-tl-wp/unimatic-tl-wp_operating-instructions-manual_846580007.webp)
2
Using for the first time
2.1
Note
The appliance can only be operated
after standing in the normal operating posi-
tion for about 2 hours
.
The appliance must be installed and connected to the electricity supply in accordance
with the separate installation instructions. Have a qualified fitter/electrician carry out the
necessary work.
2.2
Function description
When the appliance is connected to the power supply for the first time, it is possible to
select a function test. The purpose of the function test is to check the installation. It takes
about 3 minutes. The function test can be selected immediately after installation. The
heat pump is not started during the function test. Before the definitive initial start-up of
the appliance, it must stand in the normal operating position for around 2 hours, other-
wise the heat pump could become damaged.
The function test cannot be aborted by interrupting the power supply.
Once the function test has been run or aborted, it can no longer be selected and
the appliance enters the normal selection mode.
2.3
Starting the function test
▸ Connect the appliance to the mains and wait for
to appear in the display.
▸ Use the
button to start the function test.
The function test can be interrupted in two ways:
▸ Open the appliance door
.
–
flashes in the display.
The indicator light for the
button flashes after closing the appliance door.
Or:
▸ Press the
button.
–
The indicator light for the
button flashes.
Continuing the function test:
▸ Press the
button.
–
The duration remaining appears in the display, e. g.
.
Aborting the function test:
▸ Pressing the
button aborts the function test and all displays go out.
End of function test:
All the displays go out when the function test has finished.
7