Installation instructions
Induction hob
GK11TIFKZ | GK11TIFKZS | CTI6T96FKTFHD
1032691-10
22/06/2022
1032691-10
4
Surface-mounted installation with DualDesign
The layout of the hob to be fitted may differ from the hob illustrated!
≥2×881
2×498
Drawer/Cabinet
900
A
886±1
≥5
0
490±1
≥5
0
B
825
=
=
≥490
2
501
897
H
Y
Y
Ri
Ra
≥10
*
B
Air inlet
H
Y – Y
Ventilation protective plate
* The required clearance must be observed!
2
The front and rear pegs are reinforced underneath. The strut width is determined by the producer of the stone worktop. The
minimum peg width can vary according to the properties of the stone.
Type designation
A Depends on producer
B
H
Corner radius Ra/Ri
GK11TIFKZ, GK11TIFKZS
CTI6T96FKTFHD
≥40 mm
≥82 mm
72 mm
5/1.5 mm
A
Worktop depth
B
Required clearance for service replacement over the entire cut-out area.
H
Dimension from the top of the work surface to the underside of the hob
Ri
Corner radii of appliance
Ra
Outer corner radii of cut-out
Installation
1.
Create an accurate installation cut-out.
2.
Stick the sealing tape to the underside of the glass.
3.
Carefully put the appliance in the installation cut-out and press against the worktop with sufficient overlap.