Installation instructions
Heat pump dryer
One-family household
J296.113-0
25.6.08 ITH
5
Washer-dryer combinations
䡲
Can be connected to a double drain trap.
Washer-dryer-combination
Installation side by side
with combi drainage set W5.4917
The installation can be checked by means of a function test. It lasts about 3 minutes. The heat pump is not turned on. Once the function
test has been run, it can no longer be selected and the appliance enters the normal selection mode.
A
Plug the appliance in at the mains or turn the wall switch on.
A
Start the function test with the
button.
– The function test runs (the washing drum reverses and the process fan starts).
A
While the test is running, check the stability of the appliance. If necessary, readjust the adjuster feet until the appliance stands
firmly on the floor.
with combi drainage set W5.4917
with drainage into fixed upright outflow pipe
5. Using for the first time / fine levelling
The appliance must be allowed to stand in the standard operating position for about 2 hours before using for the first time. Fail-
ure to observe this can result in damage to the appliance.
The function test cannot be interrupted by pressing the
button or by disconnecting the power.
max.
700
max.
700
max.
700
