V-TAC VT-66036103, Инструкция по эксплуатации

Страница: 15 / 44

12
Step1. Check the grid voltage
.
1.1 Check the grid voltage and compare with the permissive voltage range (Please refer to technical data).
1.2 Disconnect the circuit board from all the phases and secure against re-connection.
Step
2
.
Remove the waterproof lid from the grid port on the inverter.
Step3. Make AC
and EPS
wires.
3.1 Choose the appropriate wire(Cable size: refer to Table
1
).
3.2
Reserve about 60mm of conductor material sectional area and remove 10mm of insulation from the end of wire.
3.
3 Separate the docking screw cap of the AC terminal from the housing portion and insert stripped wires into AC
terminal and tighten the screws with a hexagonal wrench.
3.
4
Tighten the docking screw cap and housing portion of the AC terminal.
10mm
60mm
Step4. Connect the AC connector to the GRID port of the inverter and tighten the screw cap .
Connect the
LOAD
connector to the
EPS
port of the inverter and tighten the screw cap .
Note: Connect the AC connector to the GRID
into grid interface.
EPS
GRID