- Please turn off the Power before starting the installation.
- Installation shall only be done by a certified electrician.
- The magnetic suction track needs to be equipped with a 24V DC switching
power supply which cannot be directly connected to the municipal electricity.
- Lighting and other power lines (such as AC or high-power electric equipment)
should be separated or kept at a distance.
- Before installing/repairing the lamps, make sure that the power supply has
been cut off and that the connection is correct before the power supply is
switched on [Risk of electric shock].
- Please do not deconstruct or alter the lamp to prevent risk of electric shock,
malfunctions, or any kind of accident.
- Do not touch the lamp, when the product is switched on/off, the product is high
in temperature.
- Do not install the product with wet hands
- There should be no strong alternating magnetic field around the lamp.
- The built-in magnetic structure of the lamp has great magnetic attraction.
Please be careful when installing the track of the lamp to avoid getting injuries.
- The safety buckle should be locked in place when the lamps and lanterns are
put on track to avoid risk of falling lamp.
- The actual power of the product ranges from 90% to 110% of the nominal
power. The load current carrying capacity of the wires should be considered while
wiring.
- The force point of the ceiling in the lighting installation area must be more than
four times the weight of the lamp for safety [Risk of falling & failure].
- The lamp can not be used in violation of any fire protection regulation.
- The light source of this luminaire is not replaceable, when the light source
reaches its end of life the whole luminaire should be replaced.
- In the presence of smoke & foul odor, please cut off the power immediately and
consult the installation personnel/electrician.
EXTERNAL POWER SUPPLY INSTALLATION
1.Remove the end cap from one end of track, insert the power terminal box into the
track;
2.Put the power supply on the ceiling and wire AC power by brown/blue wire. Take
out the DC wire red/blue from the ceiling and insert in the hole of track, then wire
with power terminal box.
Table 2
Table 1
ENGLISH
ENGLISH
