V-fit Air Cycle ATC1, Сборка и руководство пользователя

Страница: 20 / 24

Assembly
52
18
14
4L
36 8
64
51
1
50
22 36
14
18
52
4R
4
5
Remove the Screws, Nuts and Washers from the Pivot Rod (22). Push the
Handlebar Pivot Rod (22) through the support tube of the Main Frame (1).
Center the Pivot Rod (22) and rotate it until the set hole in the rod aligns
with the hole in the center of the support tube and secure with 1 x M5 x
20mm Screw (8) and 1 x M5 Curved Washer (64). Secure both Left and
Right Handlebars (4L&4R) using 1 x Wave Washer (36), 1 x M8 Thick Flat
Washer (14) and 1 x M8 Nylon Locknut (18) for each side.
Note: The M8 Nylon Locknuts (18) should be tightened fully to ensure that
the ends of the Pivot Rod (22) pass through the nylon insert in the Nylon
Locknut (18). Fit the 2 x Nut Caps (52) over the locknuts when they are fully
tightened. Moisten the inside of the Foam Grips (47) with a little water or
household furniture polish and slide onto both ends of the Handlebar (4L&4R).
Attach the Sensor Wire (51) to the back of the Monitor (50).
Now slide the Monitor (50) onto the Monitor Mount Bracket at the front
of the Main Frame (1).
Unclip the battery cover and insert 2 x AA Batteries. (NOT SUPPLIED)
50
51
47
Page 20