5.3 SELECT WEIGHT UNIT
Press
MODE
to shift between metric or avoirdupois weight
units. The weight unit used before power off would be
employed when the scale is turned on again.
NOTE:
To comply with the law of certain countries and certain
approval requirements, the avoirdupois weight units may
be disabled. Contact your dealer for more information.
5.4 SET BACKLIGHT
Follow the below steps to turn on and off backlight (if
purchased).
a. Scale is on
b. Press and hold
ON/RE-ZERO
until backlight is
activated;
or press
MODE
to shift between metric
and avoirdupois weight to turn on and off backlight
5.5 SMART POWER SAVING FUNCTION
The backlight function will turn off when constant/zero
weight is detected and remains stable for about 20/10
seconds.
Backlight will be automatically turned on again when
a new weight is detected.
5.6 SET DISPLAYED VALUE TO ZERO WHEN UNLOADED
By pressing
ON/RE-ZERO,
a positive or negative weight
displayed will be set to zero and
ZERO INDICATOR
appears.
Refer to
SPECIFICATIONS
for maximum zero range.
5.7 TARE OFF THE WEIGHT OF A CONTAINER
When a container is used, follow the below steps to
manually tare off the weight of container and get the
net weight.
a. Remove all loads away from platter
b. Make sure that the
ZERO INDICATOR
is on
c. Place the container on the platter
d. Press
ON/RE-ZERO
After
ON/RE-ZERO
is pressed, the
TARE INDICATOR
would
appear.
Refer to
5.2
for weighing procedures. Weight displayed
under is the net weight of the subject matter. Refer
to
SPECIFICATIONS
for maximum tare range.
5.8 CLEAR THE TARE FUNCTION
a. Remove all loads from platter
