UUGear PiGear Nano, Руководство пользователя

Страница: 14 / 46

11
8. Jumper Settings
After installing the software, you may need to do some jumper settings to make the board fully
functional.
If you are using Raspberry Pi Compute Module 4 with eMMC, you need to remove the jumper cap
from the "Disable eMMC Boot" jumper after installing the operating system into eMMC. This jumper
is part of the multifunctional 2x7 pin jumper, which will be introduced later.
With the software installed, the e-latching power switch is supported on software level. However, you
still need to remove the "bypass power switch" jumper cap, otherwise PiGear Nano cannot fully cut
the power after system shutdown. If you do not want to use the e-latch power switch, you can keep
this jumper cap in place.