UTStarcom UT-300R2, Руководство пользователя

Страница: 16 / 85

3
Before Configuring UT-300R2
The factory default settings of UT-300R2 optimized all functions
so as to enable it to operate on most network conditions.
Usually, for the users with simple network topology, the default
settings can meet the basic requirements and don’t need to
change. In order to access the web-based software built into
the UT-300R2, you should check the IP settings on your
computer and change them if necessary to access web-based
manager to configure the device.
Set up TCP/IP on Your PC
In order to configure your system to receive IP settings from the
UT-300R2 it must first have the TCP/IP protocol installed. If you
have an Ethernet port on your computer, it probably already has
TCP/IP protocol installed. Please follow the instructions to
check your IP protocol:
1 In Windows task bar, click the Start button, point to
Settings>Network and Dial-up Connection > and click on
Local Connection.
2 Click on
Properties
> Select Internet Protocol (TCP/IP)
and then Click Properties .
3 Click on the button labeled use the following IP address,
then you can set the IP address and Subnet mask, for
example, 192.168.1.100 and 255.255.255.0.
3