Installation Guide
Roseberry Back-To-Wall Toilet Unit
Important Information
•
Read the instructions carefully.
•
Check the product for any signs of damage and remove any protective film.
•
It is recommended that a technically competent installer undertakes installation.
•
It is the insta
ller’s responsibility to carry out a thorough assessment of the wall type and the
weight of the cabinet and use appropriate fixings.
•
Care should be taken when drilling walls to avoid any hidden wires or pipes.
Installation
Remove the top fascia panel first by pulling it away from the cabinet
with equal force on each side.
Turn the unit upside down. Push the legs firmly into the leg sockets.
Stand the unit back on its legs against the wall. Adjust the legs
on the units until they are level. Secure the unit to the wall by
drilling through the back rail and using suitable fixings for the wall type.
If this cabinet is being fitted in a run, secure the units together with
suitable fixings through the gables. Try to hide the fixings where
possible behind shelves or hinge plates.
To cut the lower fascia panel to accommodate the soil pipe and cistern
flush pipe, use a jigsaw with a fine-toothed blade suitable for timber.
Ensure that the room is well ventilated when cutting the material.
All cut edges must be sealed with PVA glue or good-quality, sanitary
grade silicone sealant to prevent the ingression of moisture.
Fit the top fascia panel last, after plumbing connections have been made
and installation completed.
Care & Maintenance
Furniture should be regularly dusted with a soft cotton or micro-fibre cloth. For more thorough
cleaning, occasionally wipe your furniture with a soft cloth dampened with a mild detergent
solution. Surfaces should be thoroughly dried with a lint free cloth to prevent watermarks. Under
no circumstances should solvent cleaning agents, bleach or abrasive cleaning agents or cloths be
used. Glass or mirrored panels should be cleaned using a non-solvent based glass cleaner and a
soft cloth. Spills should be removed immediately using a clean cloth. All bathroom furniture will
deteriorate through prolonged periods of exposure to high levels of condensation so bathrooms
must be adequately ventilated using suitable extraction. Failure to ensure adequate ventilation
may invalidate your guarantee. If it required to use the touch-up paint, ensure that the surface is
dry and clean and free from dust or oils. The paint should be applied using a slightly damp
sponge. Carefully dap the paint onto the required area and leave it to dry. Multiple coats may be
required to build-up the paint to give the required finish.
