Installation Guide
Roseberry Illuminated Mirror Back Panel
Important Information
•
Read the instructions carefully.
•
Check the product for any signs of damage and remove any protective film.
•
It is recommended that a technically competent installer undertakes installation.
•
I
t is the installer’s responsibility to carry out a thorough assessment of the wall type and the
weight of the product and use appropriate fixings.
•
Care should be taken when drilling walls to avoid any hidden wires or pipes.
•
Ensure that the electrical supply is turned off before commencing any work. It is
recommended that this product is fitted by a suitably qualified Part P registered electrician in
accordance with current IEE & Building Regulations.
Installation
Push the plastic inserts into the rear of the mirror panel. Ensure that
the inserts are aligned in the correct direction. Once the plastic inserts
have been fitted, they cannot be removed.
Measure the distance between the centres of the two plastic inserts.
Transfer this measurement onto the wall. The electrical feed for the
illuminated mirror (supplied separately) should pass through the hole
in the centre of the mirror panel when it is hung on the wall.
Drill the wall and secure the fixings at the marked positions. Plasterboard
or stud walls may require specialist fixings (not supplied).
Note
: you must
ensure that the fixings are suitable for the weight of the mirror and the
wall type.
Pass the electrical feed through the centre of the mirror panel and hang
it on the wall fixings, ensuring that they are located securely in the plastic
inserts.
Screw the 10 x ¾ pan head screws into the holes made in the front of the frame. Ensure that the
screws protrude enough for the illuminated mirror (supplied separately) to be hung securely.
Connect the electrical feed to the illuminated mirror (supplied separately) and hang it onto the 10x
¾ pan head screws, ensuring that it is securely located.
If required, the bottom of the mirror can be secured to the back panel using a suitable adhesive.
Care & Maintenance
Furniture should be regularly dusted with a soft cotton or micro-fibre cloth. For more thorough
cleaning, occasionally wipe your furniture with a soft cloth dampened with a mild detergent
solution. Surfaces should be thoroughly dried with a lint free cloth to prevent watermarks. Under
no circumstances should solvent cleaning agents, bleach or abrasive cleaning agents or cloths be
used. Glass or mirrored panels should be cleaned using a non-solvent based glass cleaner and a
soft cloth. Spills should be removed immediately using a clean cloth. All bathroom furniture will
deteriorate through prolonged periods of exposure to high levels of condensation so bathrooms
must be adequately ventilated using suitable extraction. Failure to ensure adequate ventilation
may invalidate your guarantee. If it required to use the touch-up paint, ensure that the surface is
dry and clean and free from dust or oils. The paint should be applied using a slightly damp
sponge. Carefully dap the paint onto the required area and leave it to dry. Multiple coats may be
required to build-up the paint to give the required finish.
