Installation Guide
Downton Bath Side Panel
Important Information
•
Read the instructions carefully.
•
Ensure product contents are complete.
•
Check the product for any signs of damage and remove all protective film.
•
It is recommended that a technically competent installer undertakes installation.
•
It is the install
er’s responsibility to carry out a thorough assessment of the installation
environment (i.e. wall type/structure) and use appropriate fixings.
•
Care should be taken when drilling to avoid any hidden wires or pipes.
•
If the panel is required to be trimmed, a fine-toothed saw should be used. Ensure that the
room is well ventilated and that any cut edges are sealed with PVA glue or silicone sealant to
prevent water ingression.
Installation
Set the height of the bath to suit the height of the bath panel according to the
instructions supplied with the bath. Ensure that when the brackets and bath
panel are fitted, the panel sits 4mm proud of the bath rim.
If you are installing this side panel in conjunction with an end
panel, fit the end panel first according to the instructions supplied
with it.
Screw three black Keku clips to the underside of the wooden batten
underneath the bath rim using the screws provided. The three clips
should be equally spaced along the length of the bath. Use the diagram
as a guide to how the Keku clips are fitted.
The matching Keku clips should be screwed to the rear of the bath
panel using the screws supplied. Measure carefully to ensure that the
clips on the rear of the bath panel will engage with the clips screwed
to the bath.
If the bath panel is being fitted between two walls, t
he two “L” brackets should
be secured to the walls to prevent the panel from being pushed inwards. Ensure
suitable fixings are used.
If the bath panel is being used in conjunction with an end panel, secure
one “L”
bracket to the wall to prevent the panel from being pushed inwards. On the opposite
side to the wall secure the bath panel in place using a Keku clip. This Keku clip is
supplied with the end panel, along with instruction on how it is fitted.
Once fully installed, seal around the bath panel on all joints using a good quality, sanitary-grade
silicone sealant.
Care & Maintenance
Furniture should be regularly dusted with a soft cotton or micro-fibre cloth. For more thorough
cleaning, occasionally wipe your furniture with a soft cloth dampened with a mild detergent
solution. Surfaces should be thoroughly dried with a lint free cloth to prevent watermarks. Under
no circumstances should solvent cleaning agents, bleach or abrasive cleaning agents or cloths be
used. Glass or mirrored panels should be cleaned using a non-solvent based glass cleaner and a
soft cloth. Spills should be removed immediately using a clean cloth. All bathroom furniture will
deteriorate through prolonged periods of exposure to high levels of condensation so bathrooms
must be adequately ventilated using suitable extraction. Failure to ensure adequate ventilation
may invalidate your guarantee.
